Commissioning Qualification and Validation the Concept of CQV – Part 2

Home » Commissioning Qualification and Validation the Concept of CQV – Part 2

Description:

This is the second course in this program and introduces the key concepts around identifying risk, and risk analysis including risk evaluation, mitigation and communication. You should take this course after the first course on overview and risk-based impact assessment, but before the course on qualification, validation and supporting quality.

Curriculum for this course:

Course Introduction

Course Introduction	1 min 10 secs
Learning Objectives	1 min 31 secs

Module 1: User Requirement Specification

URS Overview	1 min 05 sec
URS Preparation Process – Part 1	1 min 10 secs
URS Preparation Process – Part 2	1 min 05 secs
Review Activity #1	1 min 42 secs

Module 2: Risk Management

Functional Risk Assessment	1 min 12 secs
Risk Identification	1 mins 29 secs
Risk Analysis	1 min 21 secs
Risk Evaluation	1 min 25 secs
Post-Mitigation Residual Risk Acceptance	1 min 10 secs
Risk Communication	1 min 09 secs
Risk Review	1 min 30 secs
Review Activity #1	1 min 11 secs
Review Activity #2	1 min 14 secs

Module 3: Design Review and FAT

Design Review (DR) and Design Qualification (DQ) – Part 1	58 secs
Design Review (DR) and Design Qualification (DQ) – Part 2	1 min 20 secs
Design Review (DR) and Design Qualification (DQ) – Part 3	1 min 01secs
Factory Acceptance Test (FAT)	1 min 19 secs
Site Acceptance Test (SAT)	1 min 14 secs
Review Activity #1	1 min 18 secs